Building An LED Grow Light Set For Your Indoor Garden
The LED systems you see in stores and over the Internet are expensive. In reality, making your own may only cost as much as $20 for a large system. The only thing is that it can be hard to create your own, especially if you don’t have any prior experience with electronics.
The first thing to do is to get all of the tools and parts. You will need some sort of box to hold the lights in place. You can use a large plastic tub you find at general stores if needed. Find a power supply that supports 10 volts, blue and red LED lights to fill the compartment, wire, and then if needed a couple transistors and resistors.
Like any good plan, you must write down what you are planning to build in order to make it work correctly. It’s best if you have some graph paper and a pencil to do it on, just so there is no confusion on what you are making. If you don’t know electronics technology, you should look on the Internet for symbols used to construct your logic diagram. If you do it properly, you shouldn’t have a problem building it.
You will need two things during the building phase. It’s nice to get a solderless circuit board to test the circuit and see if it works. That way you don’t waste your time building something that was flawed from the start. The circuit board is the next phase, in which you use solder to connect all the points. You could just use the solderless board if you wanted, but it would be less sturdy.
The plastic tub mentioned earlier is to fix your circuit inside of. It will provide a natural directional spotlight that allows you to direct the flow of light to a fixed area. Without it, the LED lights would illuminate the entire room and this may not be desirable. You can skip the plastic tub if this won’t be a problem, and if the room is just for indoor gardening, it shouldn’t be a problem at all.
Once entirely complete, you should start looking on ways to improve your design. For instance, some make the mistake of using green LED lights, when in fact you only need blue and red to fuel the right source of energy to plants. You can also increase the efficiency of your circuit if you find it is consuming too much energy.
In Conclusion
There are stores that sell these sets and kits already, so look into buying an already made LED growth system. You will save time, and maybe even money if you aren’t an expert at electronics technology. Shipping is also fast- so you can have it delivered in just days.
Learn more on LED grow lights and indoor grow lights.